ISOPOLANT
Aqua 2K

ISOPOLANT
Aqua 2K
Two-component epoxy coating / low viscosity water-based primer



A two-component, special epoxy coating / water-based primer designed for use at a ratio of 1:1 by volume. The viscosity of the material is low, and the shelf life is for a long time, which makes it ideal for use in everyday life, independently without professional skills.
Application area

• Primer for polyurethane and epoxy coatings
• For sealing the concrete
• Dust proof coating
Features and benefits
  • Ratio of application - 1:1 in volume
  • Fast cure even at lower temperatures
  • Low odor, safe and non-flammable, zero VOC (volatile organic compounds)
  • Suitable for indoor use
  • Strong adhesion even to damp and wet concrete
  • Excellent mechanical resistance and resistance to abrasion
Application procedure
1
Before applying thoroughly clean from dust, dirt, rust, oil products, cement solution, layer of plaster, paint and other materials that prevent adhesion. Remove particles, loose and easily peeling layers and other foreign materials must also be removed.
2
Mix the two components until a homogeneous mass with a mixer at low speed (up to 300 r/ min), can be diluted to 10% with pure water.
• As a primer - apply with a brush or roller, in one or two thin layers, with common maximum flow 150-200 ml/m2.
• As a coating - apply using a roller or notched trowel in three layers, with a total flow rate of 500-600 ml/m2.
3
The number of hours of the time coating of the next layer cannot be defined since it is a strongly dependent on weather conditions: it may be up to 2 hours during the summer and up to 24 hours during the winter. Use the following rule to determine when the next layer is applied.
4
Recoating with the material is possible, when the preceding layer hardens to such an extent that it cannot be pierced with a fingernail.
• The viability of the material after mixing is 1 hour at 25° C.
• Do not use when temperature is below 5° C.
• Before applying (in the summer), heated concrete should be moistened.
General information
Technical specifications
In liquid form (before application, after mixing):

Component A - milky white
Component B - yellow

Properties
Units
Method
Specification
Viscosity (Brookfield) of the mixed product
cP
ASTM D2196-86 at 25°C
120
Specific weight
g/cm3
ASTM D1475 / DIN 53217 / ISO 2811 at 20°C
+/- 1
Mix ratio
A:B, in volume
-
1:1
Сuring time at 77° F (25°) and relative to the second humidities of 55%
hours
-
3-5
Complete hardening
days
-
3
Reapplication Time
-
-
When a material hardens to such an extent that it can not be pierced with a fingernail
Working life after mixing at 25° C
hours
-
1
In cured form (after use):
Properties
Units
Method
Specification
Adhesion to concrete
kg/cm2
(N/mm2)
ASTM D4541
>30
(>3)
Abrasion resistance
Gr
ASTM D4541
(Taber 503, CS17, 1.0kg, 1,000 revs.)
110 * 10-3
Get TDS on this material
ANT ALLIANCE is an exclusive supplier of ISOPOLANT products worldwide.